Allied Telesis AT-S63 - Manual (Page 472)

Chapter 25: Internet Group Management Protocol (IGMP) Snooping Commands
472 Section III: Snooping Protocols
Examples
The following command activates IGMP snooping, sets the IGMP topology
to Multi-Host, and sets the timeout value to 120 seconds:
set ip igmp snoopingstatus=enabled hoststatus=multihost
timeout=120
The following command changes the topology to Single-Host:
set ip igmp hoststatus=singlehost
The following command disables IGMP snooping:
set ip igmp snoopingstatus=disabled
Equivalent Commands
disable igmpsnooping
For information, refer to “DISABLE IGMPSNOOPING” on page 468.
enable igmpsnooping
For information, refer to “ENABLE IGMPSNOOPING” on page 469.
AlliedWare Plus
Command
Syntax
To set the maximum number of multicast addresses the switch can learn:
ip igmp limit numbermulticastgroups
To set the time-out period for inactive host nodes:
ip igmp querier-timeout timeout
To set the host node topology:
ip igmp status single|multiple
To specify a router port:
ip igmp router interface port
Mode
Configure mode
Description
These AlliedWare Plus commands are equivalent to the standard
command.