Set switch trunk, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 215
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
215
SET SWITCH TRUNK
Syntax
set switch trunk=
name
select=macsrc|macdest|macboth|ipsrc|ipdest|ipboth
Parameters
trunk
Specifies the name of the static port trunk.
select
Specifies the load distribution method. Options are:
macsrc
Source MAC address.
macdest
Destination MAC address.
macboth
Source address/destination MAC
address.
ipsrc
Source IP address.
ipdest
Destination IP address.
ipboth
Source address/destination IP
address.
Description
This command is used to change the load distribution methods of existing
static port trunks.
Example
The following command changes the load distribution method to source
MAC address for a trunk named “Load11”:
set switch trunk=Load11 select=macsrc
AlliedWare Plus
Command
Syntax
interface
trunk_name
port-channel load-balance dst-ip|dst-mac|src-dst-ip|
src-dst-mac|src-ip|src-mac
Mode
Static Port Trunk Interface mode
Command
Available
AlliedWare Plus