Allied Telesis AT-S63 - Manual (Page 619)

AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols 619
ENABLE MSTP
Syntax
enable mstp
Parameters
None.
Description
This command enables Multiple Spanning Tree Protocol on the switch or
stack. To view the current status of MSTP, refer to “SHOW MSTP” on
page 635.
You must select MSTP as the active spanning tree on the switch before
you can enable it with this command. To activate MSTP, see “ACTIVATE
MSTP” on page 612.
Example
The following command enables MSTP:
enable mstp
AlliedWare Plus
Command
Syntax
spanning-tree mstp enable
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mstp enable
Command
Available
AlliedWare Plus