Allied Telesis AT-S63 - Manual (Page 97)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 97
 MAC address - The MAC address of the switch. This value cannot be
changed.
 VLAN mode - The switch’s VLAN mode. The three possible VLAN
modes are:
 User configured (for creating your own port-based and tagged
VLANs)
 802.1Q-compliant
 Non-802.1Q-compliant.
The default is user configured. To set a switch’s VLAN mode, refer to
“SET SWITCH VLANMODE” on page 657.
 Ingress filtering - The status of ingress filtering on the switch. When
ingress filtering is activated, tagged frames are filtered when they are
received on a port. When ingress filtering is deactivated, which is the
default, tagged frames are filtered before they are transmitted out a
port. To set ingress filtering, refer to “SET SWITCH INFILTERING” on
page 656.
 Active Spanning Tree version - The spanning tree protocol that has
been designated as the active protocol on the switch. To configure or
enable a spanning tree protocol, you must first designate it as the
active protocol on the switch. The switch supports, STP, RSTP, and
MSTP. The default is RSTP. To select an active spanning tree
protocol, refer to “ACTIVATE STP” on page 574, “ACTIVATE RSTP”
on page 590, and “ACTIVATE MSTP” on page 612.
 Mirroring state - The status of port mirroring. The display includes the
destination port as well as the ingress and egress source ports if port
mirroring is activated on the switch. To configure port mirroring, refer to
“SET SWITCH MIRROR” on page 238 and “SET SWITCH PORT
MIRROR” on page 239.
 Enhanced stacking mode - The enhanced stacking mode of the switch,
which can be master, slave, or unavailable. The default is slave. To set
the enhanced stacking status, refer to “SET SWITCH STACKMODE”
on page 112.
 Console disconnect timer interval - The current value of the console
timer, used by the management software to end inactive management
sessions. The AT-S63 Management Software ends a local or remote
management session if it does not detect any management activity for
the duration of the console timer. The default is 10 minutes. To set the
console timer, refer to “SET SWITCH CONSOLETIMER” on page 84.
 Web server status - The status of the web server. When the web
server is disabled, you cannot remotely manage the switch using a
web browser and the web browser interface. The default setting is
enabled. To enable or disable the server, refer to “ENABLE HTTP
SERVER” on page 837 and “DISABLE HTTP SERVER” on page 836.