Set time, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 89
Advertising
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
89
SET TIME
Syntax
set time=
hh:mm:ss
Parameter
time
Specifies the hour, minute, and second for the switch’s
time in 24-hour format.
Description
This command is used to set the time on the switch if you are using an
SNTP server. With its onboard battery, the AT-9400 Switch can maintain
the time even when the unit is powered off or reset.
Example
The following command sets the switch’s time to 4:34 pm and 52 seconds:
set time=16:34:52
AlliedWare Plus
Command
The AlliedWare Plus command for setting the time is also the command
for setting the date. For information, refer to the AlliedWare Plus command
in “SET DATE” on page 81.
Command
Available
AlliedWare Plus
Advertising