Allied Telesis AT-S63 - Manual (Page 124)

Chapter 6: Simple Network Time Protocol (SNTP) Commands
124 Section I: Basic Operations
SET SNTP
Syntax
set sntp [dst=enabled|disabled] [pollinterval= value ]
[utcoffset= value ]
Parameters
dst Enables or disables daylight savings time.
pollinterval Specifies the time interval between two successive
queries by the STNP client on the switch to the SNTP
server. The range is 60 to 1200 seconds. The default
is 600 seconds.
utcoffset Specifies the time difference in hours between UTC
and local time. The range is -12 to +12 hours. The
default is 0 hours.
Description
This command enables or disables daylight savings time and sets the
polling and UTC offset times for the SNTP client software.
Note
The switch does not set the DST automatically. If the switch is in a
locale that uses DST, you must remember to enable this in April
when DST begins and disable it in October when DST ends. If the
switch is in a locale that does not use DST, set this option to
disabled all the time.
Example
The following command enables daylight savings time, sets the poll
interval to 300 seconds, and sets the UTC offset to -8 hours:
set sntp dst=enabled pollinterval=300 utcoffset=-8
AlliedWare Plus
Command
Syntax
To enable daylight savings time on the SNTP client:
clock summer-time
To disable daylight savings time:
no clock summer-time
Command
Available
AlliedWare Plus