Enable interface linktrap – Allied Telesis AT-S63 User Manual
Page 157
Advertising
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
157
ENABLE INTERFACE LINKTRAP
Syntax
enable interface=
port
linktrap
Parameter
port
Specifies the port on which you want to enable SNMP
link traps. You can configure more than one port at a
time.
Description
This command activates SNMP link traps on the port. When enabled, the
switch sends an SNMP link trap to an SNMP trap receiver whenever there
is a change to the status of a link on a port.
Note
Before the switch can send SNMP traps, you must activate SNMP
on the unit and specify one or more trap receivers.
Example
The following command enables link traps on port 21:
enable interface=21 linktrap
Advertising