Allied Telesis AT-S63 - Manual (Page 538)

Chapter 30: SNMPv3 Commands
538 Section IV: SNMPv3
DESTROY SNMPv3 TARGETPARMS
Syntax
destroy snmpv3 targetparams= targetparams
Parameter
targetparams Specifies an SNMPv3 Target Parameters table
entry.
Description
This command deletes SNMPv3 Target Parameters Table entries. After
you delete an SNMPv3 Target Parameters Table entry, you cannot
recover it.
Examples
The following command deletes an SNMPv3 Target Parameters Table
entry called “targetparameter1.”
destroy snmpv3 targetparams=targetparameter1
The following command deletes an SNMPv3 Target Parameters Table
entry called “snmpmanager.”
destroy snmpv3 targetparams=snmpmanager
AlliedWare Plus
Command
Syntax
no snmp-server targetparams target
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
This example deletes an SNMPv3 Target Parameters Table entry called
“mgrsnmpv3params”:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server targetparams mgrsnmpv3params
Command
Available
AlliedWare Plus