Awplus – Allied Telesis AT-S63 User Manual
Page 66
Chapter 3: Basic Switch Commands
66
Section I: Basic Operations
AWPLUS
Syntax
awplus
Parameters
None.
Description
This command is used to start the AlliedWare Plus command line
management session. When you enter the command, the management
software displays the prompt for the User Exec mode in Figure 26.
Figure 26. AlliedWare Plus Command Prompt - User Exec Mode
To enter the Privileged Exec mode, enter the ENABLE command, as
shown in Figure 27.
Figure 27. AlliedWare Plus Command Prompt - Privileged Exec Mode
Note
This command and the AlliedWare Plus command interface are not
supported on the Layer 2+ AT-9408LC/SP, AT-9424T/GB and
AT-9424T/SP Switches.
Example
# awplus
AlliedWare Plus (TM) AT-9448T/SP AT-S63
awplus>
AlliedWare Plus (TM) AT-9448T/SP AT-S63
awplus> enable
awplus#