Allied Telesis AT-S63 - Manual (Page 212)

Chapter 11: Static Port Trunking Commands
212 Section I: Basic Operations
DELETE SWITCH TRUNK
Syntax
delete switch trunk= name port= port
Parameters
trunk Specifies the name of the static port trunk to be
modified.
port Specifies the port to be removed from the existing port
trunk. You can remove more than one port at a time.
Description
This command removes ports from a static port trunk. To completely
remove a port trunk from a switch, see “DESTROY SWITCH TRUNK” on
page 214.
Caution
Disconnect all the data cables from the ports of the trunk on the
switch before using this command. Removing a port from a port
trunk without first disconnecting the cables may result in loops in
your network topology, which can produce broadcast storms and
poor network performance.
Note
You cannot remove ports from a trunk that has only two ports
because a static trunk must have a minimum of two ports.
Example
The following command removes port 9 from a port trunk called
Dev_trunk:
delete switch trunk=Dev_trunk port=9
AlliedWare Plus
Command
Syntax
no static-channel-group tgid
Mode
Port Interface mode
Command
Available
AlliedWare Plus