Allied Telesis AT-S63 - Manual (Page 614)

Chapter 33: Multiple Spanning Tree Protocol (MSTP) Commands
614 Section V: Spanning Tree Protocols
CREATE MSTP
Syntax
create mstp mstiid= mstiid [mstivlanassoc= vids ]
Parameters
mstiid Specifies the MSTI ID of the spanning tree instance you
want to create. You can specify only one MSTI ID at a
time. The range is 1 to 15.
mstivlanassoc Specifies the VID of the VLAN you want to associate
with the MSTI ID. You can specify more than one VID at
a time (for example, 2,5,44).
Description
This command is used to create new multiple spanning tree instances and
to associate VLANs to the instances.
The MSTIID parameter specifies the ID number for the new spanning tree
instance.
The MSTIVLANASSOC parameter specifies the VIDs of the VLANs you
want to associate with the new MSTI. The VLANs must already exist on
the switch. If you do not specify any VLANs, you can add them later using
“ADD MSTP” on page 613 or “SET MSTP MSTIVLANASSOC” on
page 628.
Examples
The following command creates the MSTI ID 8 and associates to it the
VLAN with the VID 4:
create mstp mstiid=8 mstivlanassoc=4
The following command creates the MSTI ID 11 and associates to it the
VLANs with the VIDs 24 and 44:
create mstp mstiid=11 mstivlanassoc=24,44
AlliedWare Plus
Command
Syntax
instance mstiid vids [ priority ]
Mode
Multiple spanning tree mode
Command
Available
AlliedWare Plus