Allied Telesis AT-S63 - Manual (Page 197)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 197
RESET SWITCH FDB
Syntax
reset switch fdb [port= port ]
Parameter
port Specifies the port whose dynamic MAC addresses are to
be deleted from the MAC address table. You can specify
more than one port at a time.
Description
You use this command to delete all the dynamic MAC addresses in the
MAC address table or the addresses learned on a specific port. After a
port’s dynamic MAC addresses have been deleted, the port begins to
learn new addresses.
Examples
The following command deletes all the dynamic MAC addresses in the
switch’s MAC address table:
reset switch fdb
The following command deletes all the dynamic MAC addresses learned
on port 5:
reset switch fdb port=5