Destroy log output, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 311
AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations
311
DESTROY LOG OUTPUT
Syntax
destroy log output=
output-id
Parameters
output
Specifies the output definition ID number.
Description
This command deletes output definitions. To disable an output definition
without deleting it, see “DISABLE LOG OUTPUT” on page 313.
Example
This command deletes output definition number 3:
destroy log output=3
AlliedWare Plus
Command
Syntax
no log host
ipaddress
output-id
Mode
Configure mode
Description
This AlliedWare Plus command is used like the standard command to
delete output definitions. It differs from the standard command in that it
requires an IP address of a definition’s syslog server.
Example
This command deletes output definition 4. The IP address of the syslog
server in the definition is 149.122.45.78:
awplus> enable
awplus# configure terminal
awplus(config)# no log host 149.122.45.78 4
Command
Available
AlliedWare Plus