Disable switch port, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 154
Chapter 8: Port Parameter Commands
154
Section I: Basic Operations
DISABLE SWITCH PORT
Syntax
disable switch port=
port
Parameter
port
Specifies the port to disable. You can disable more than
one port at a time.
Description
This command disables a port. When a port is disabled, it stops forwarding
traffic. The default setting for a port is enabled.
Example
The following command disables ports 12 and 24:
disable switch port=12,24
Equivalent Command
set switch port=
port
status=disable
For information, see “SET SWITCH PORT” on page 162.
AlliedWare Plus
Command
Syntax
shutdown
Mode
Port Interface mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Example
This example disables ports 15 and 16:
awplus> enable
awplus# configure terminal
awplus(config)# interface 15,16
awplus(config-if)# shutdown
Command
Available
AlliedWare Plus