Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 330
Chapter 17: Event Log and Syslog Client Commands
330
Section II: Advanced Operations
Examples
The following command displays all the entries in the event log stored in
permanent memory:
show log=permanent
The following command displays the events stored in temporary memory
in the full display mode, which adds more information:
show log=temporary full
The following command displays only those entries stored in temporary
memory and associated with the AT-S63 modules FILE and QOS:
show log=permanent module=file,qos
The following command displays the error and warning entries for the
AT-S63 module VLAN. Because the log is not specified, the temporary log
is displayed by default:
show log module=vlan severity=e,w
AlliedWare Plus
Command
Syntax
To display the event messages stored in the permanent event log, from
the oldest to the newest messages:
show log permanent
To display the event messages stored in the temporary event log, from the
newest to the oldest messages:
show log tail
Modes
User Exec mode and Privileged Exec mode
Description
These AlliedWare Plus commands do not have any of the parameters of
the standard command.
Examples
To display the events in the permanent log:
awplus# show log permanent
To display the events in the temporary event log:
awplus# show log tail