Enable vrrp, Alliedware plus command – Allied Telesis AT-S63 User Manual

Page 781

Advertising
background image

AT-S63 Management Software Command Line User’s Guide

Section VII: Internet Protocol Routing

781

ENABLE VRRP

Syntax

enable vrrp[=

vrid

|all]

Parameters

vrrp

Specifies the ID of the virtual router. The options are:

vrid

Specifies the ID of a single virtual router,
a number between 1 and 255.

all

Specifies that all the virtual routers in
which the switch participates be enabled.

Description

This command enables VRRP on the switch, or enables the switch’s
participation in a specific virtual router. VRRP is disabled on the switch by
default, and virtual routers are enabled by default when you create them.
You must enable both VRRP and the virtual router for the virtual router to
operate.

Example

This example enables the switch to participate in virtual router 42:

enable vrrp=42

AlliedWare Plus

Command

Syntax

router vrrp

vrid

enable

Modes

For the ROUTER VRRP command:

Configure mode

For the DISABLE command:

Router mode

Description

These AlliedWare Plus commands are used to enable individual virtual
routers. To enable VRRP on the switch, use the standard ENABLE VRRP

Command

Available

AlliedWare Plus

Advertising