Allied Telesis AT-S63 - Manual (Page 482)

Chapter 26: Internet Group Management Protocol (IGMP) Snooping Querier Commands
482 Section III: Snooping Protocols
SHOW IP IGMP QUERIERLIST
Syntax
show ip igmp querierlist
Parameters
None.
Description
This command displays the IGMP snooping querier parameters. Figure 66
illustrates the information.
Figure 66. SHOW IP IGMP QUERIER Command
The columns are defined here:
 VLAN Querier ID Status: This column displays the ID of the VLAN
where IGMP snooping querier is added.
 Interface IP Address: This column displays the IP address of the
routing interface in the VLAN.
 Exp. Time: The amount of time remaining before the switch sends
another query. When the querier is first enabled, the switch sends a
query every 31 seconds three times. Afterwards, it sends queries
every 125 seconds.
 Query Version: The type of queries the switch is sending. This will be
either version 1 or 2.
 Version 1 Source Ports: If there are nodes that are sending version 1
requests, this column lists their port numbers.
AlliedWare Plus
Command
Syntax
show ip igmp querier
Mode
User Exec mode and Privileged Exec mode
Command
Available
AlliedWare Plus
VLAN Querier Interface Exp. Query Version 1
ID Status IP Address Time Version Source Port
------------------------------------------------------------
12 Querier 149.122.12.45 48 Ver 2