Allied Telesis AT-S63 - Manual (Page 84)

Chapter 3: Basic Switch Commands
84 Section I: Basic Operations
SET SWITCH CONSOLETIMER
Syntax
set switch consoletimer= value
Parameter
consoletimer Specifies the console timer in minutes. The range is 1
to 60 minutes. The default is 10 minutes.
Description
This command sets the console timer, which is used by the management
software to end inactive management sessions. The AT-S63 Management
Software automatically ends a session if it does not detect any
management activity for the duration of the console timer. This security
feature can prevent unauthorized individuals from using your management
station should you step away from your system while configuring a switch.
To view the current console timer setting, refer to “SHOW SWITCH
MODULE” on page 96.
Example
The following command sets the console timer to 25 minutes:
set switch consoletimer=25
AlliedWare Plus
Command
Syntax
exec-timeout value
Mode
Line Console mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Example
This example sets the console timer to 15 minutes:
awplus> enable
awplus# configure terminal
awplus(config)# line console 0
awplus(config-line)# exec-timeout 15
Command
Available
AlliedWare Plus