Activate rstp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 590
Chapter 32: Rapid Spanning Tree Protocol (RSTP) Commands
590
Section V: Spanning Tree Protocols
ACTIVATE RSTP
Syntax
activate rstp
Parameters
None.
Description
Use this command to designate RSTP as the active spanning tree. After
you activate RSTP, you can enable or disable it using the ENABLE RSTP
and DISABLE RSTP commands. RSTP is active on a switch or stack only
after you have designated it as the active spanning tree with this
command and enabled it with the ENABLE RSTP command.
Only one spanning tree protocol, STP, RSTP, or MSTP, can be active on
the switch or stack at a time.
Example
The following command designates RSTP as the active spanning tree:
activate rstp
AlliedWare Plus
Command
Syntax
spanning-tree mode rstp
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree mode rstp
Command
Available
AlliedWare Plus