Allied Telesis AT-S63 - Manual (Page 313)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 313
DISABLE LOG OUTPUT
Syntax
disable log output[= output-id ]
Parameters
output Specifies the output definition ID number to disable.
Not specifying an output definition disables all
definitions.
Description
This command disables an output definition. When disabled, no event
messages are sent to the specified device, although the definition still
exists. To permanently remove an output definition, see “DESTROY LOG
OUTPUT” on page 311. To enable the output definition again, see
“ENABLE LOG OUTPUT” on page 316.
Example
The following command disables (but does not delete) output definition
number 7:
disable log output=7
The following command disables all configured definitions:
disable log output
AlliedWare Plus
Command
Syntax
no log enable output-id
Mode
Configure mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Example
This command disables output definition number 2:
Command
Available
AlliedWare Plus