Add link-flap, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 244
Chapter 14: Link-flap Protection Commands
244
Section I: Basic Operations
ADD LINK-FLAP
Syntax
add link-flap port=
port
|all
Parameters
port
Specifies a port for link-flap protection. You can
configure more than one port at a time with this
command. To specify all of the ports, use the ALL
option.
Description
This command is used to designate ports for link-flap protection. If ports
have already been designated for link-flap protection, this command adds
the new ports to the existing ports. If you want to remove the existing ports
while designating new ports, use the ENABLE LINK-FLAP command
instead. For instructions, refer to “ENABLE LINK-FLAP” on page 248.
The status of link-flap protection on the switch is not changed by this
command. If it is disabled, it remains disabled. If it is enabled, it remains
enabled. To disable or enable link-flap protection with the standard
commands, refer to “DISABLE LINK-FLAP” on page 247 and “ENABLE
LINK-FLAP” on page 248, respectively.
Example
This example adds link-flap protection to ports 15 and 22:
add link-flap port=15,22
AlliedWare Plus
Command
Syntax
link-flap protection
Mode
Port Interface mode
Description
This AlliedWare Plus command is used like the standard command to add
ports for link-flap protection. It differs from the standard command in that if
link-flap protection on the switch is disabled, it enables it.
Command
Available
AlliedWare Plus