Show snmpv3 targetaddr, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 566
Chapter 30: SNMPv3 Commands
566
Section IV: SNMPv3
SHOW SNMPV3 TARGETADDR
Syntax
show snmpv3 targetaddr[=
targetaddr
]
Parameter
targetaddr
Specifies an SNMPv3 Target Address Table entry.
Description
This command displays SNMPv3 Target Address Table entries. You can
display one or all of the table entries.
Examples
The following command displays the SNMPv3 Target Address Table entry
called “snmpv3host55”:
show snmpv3 targetaddr=snmpv3host55
The following command displays all of the SNMPv3 Target Address Table
entries:
show snmpv3 targetaddr
AlliedWare Plus
Command
Syntax
show snmp-server targetaddr
Mode
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command displays the entire SNMPv3 Target
Address Table. You cannot specify an individual entry as you can with the
standard command.
Example
awplus# show snmp-server targetaddr
Command
Available
AlliedWare Plus