Disable snmp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 140
Chapter 7: SNMPv1 and SNMPv2c Commands
140
Section I: Basic Features
DISABLE SNMP
Syntax
disable snmp
Parameters
None.
Description
This command disables SNMP on the switch. You cannot manage the unit
from an SNMP management station when SNMP is disabled. The default
setting for SNMP is disabled. This command does not affect the status of
authentication failure traps. To disable the traps, refer to “DISABLE SNMP
AUTHENTICATETRAP” on page 141.
Example
The following command disables SNMP on the switch:
disable snmp
AlliedWare Plus
Command
Syntax
no snmp-server enable trap
Mode
Configure mode
Description
This AlliedWare Plus command disables both SNMP and authentication
failure traps. The standard commands have a separate command for
disabling authentication failure traps.
Example
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server enable trap
Command
Available
AlliedWare Plus