Allied Telesis AT-S63 - Manual (Page 747)

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 747
SHOW IP RIP COUNTER
Syntax
show ip rip counter
Parameters
counter Displays RIP packet statistics for all interfaces where
RIP has been added. This parameter cannot be used
with the INTERFACE parameter.
Description
This command displays RIP statistics for the entire switch. An example of
the information displayed by this command is shown in Figure 83.
Figure 83. SHOW IP RIP Command with COUNTER Parameter
The columns in the display are described here:
 inResponse - The number of response packets received.
 inRequests - The number of request packets received.
 inDiscards - The number of packets discarded. Packets may be
discarded due to an authentication failure or a mismatched sequence
number of a triggered acknowledgement.
 outResponse - The number of response packets sent.
 outRequests - The number of request packets sent.
 outTrigResponse - The number of triggered response packets sent.
 outErrors - The number of errors encountered when sending a request
or response RIP message.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
IP RIP Counter Summary
Input:
inResponses......................5
inRequests.......................1
inDiscards.......................0
Output:
outResponses.....................6
outRequests......................2
outTrigResponses.................0
outErrors........................0