Allied Telesis AT-S63 - Manual (Page 285)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 285
LOAD METHOD=XMODEM
Syntax 1: Downloading Files to the File System
load method=xmodem destfile=[cflash:] filename
Syntax 2: Downloading New AT-S63 Management Software to a
Stand-alone Switch
load method=xmodem destfile=appblock
Syntax 3: Downloading New AT-S63 Management Software to an
AT-9400 Stack
load method=xmodem destfile=appblock module= value |all
Parameters
method Specifies a XMODEM download.
destfile Specifies the destination filename for the file. If you are
downloading a configuration file or a SSL public key
certificate, this is the name given to the file when it is
stored in the switch’s file system. The name can be from
1 to 15 alphanumeric characters, not including the three-
letter extension. If the name includes spaces, enclose it in
double quotes. The name must be unique from the files
already stored in the file system. The command will not
overwrite a preexisting file.
To download a file onto a flash memory card in the switch
rather than the file system, precede the name with
“cflash:”.
If you are downloading new AT-S63 Management
Software, specify APPBLOCK as the destination. This
specifies the application block, which is the area of flash
memory reserved for the active AT-S63 image file.
module Specifies the switches in the AT-9400 Stack to receive
the new AT-S63 Management Software. The range is 1 to
8. You can specify more than one switch (e.g., 1,2). To
update all the switches, use ALL.
General Description
These commands are used to download files and new versions of the
AT-S63 Management Software to stand-alone switches and stacks, using
XMODEM.
Command
Available
AlliedWare Plus