Allied Telesis AT-S63 - Manual (Page 737)

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 737
This command changes RIP on the VLAN11-0 interface to accept both
RIP version 1 and version 2 packets:
set ip rip interface=vlan11-0 receive=both
This command changes RIP on the VLAN22-1 interface to send and
receive RIP version 1 packets. Since version 1 does not support password
authentication, the command disables it:
set ip rip interface=vlan22-1 send=rip1 receive=rip1
authentication=none
Note
Password authentication must be disabled to change an interface
from RIP version 2 to version 1.
AlliedWare Plus
Command
Syntax
To set the version of RIP packets the routing protocol will transmit:
send rip1|rip2 interface
To set the version of RIP packets the routing protocol will accept:
recv rip1|rip2|both interface
To enable or disable password protection for RIP version 2:
authentication pass|none interface
To set the password used to authenticate RIP version 2 packets:
password password interface
To activate split horizon with poison reverse:
poison-reverse interface
To activate split horizon:
no poison-reverse interface
To enable autosummary of routes:
auto-summary interface
To disable autosummary of routes:
no auto-summary interface