Destroy switch trunk, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 214
Chapter 11: Static Port Trunking Commands
214
Section I: Basic Operations
DESTROY SWITCH TRUNK
Syntax
destroy switch trunk=
name
Parameter
trunk
Specifies the name of the trunk to be deleted.
Description
This command deletes a static port trunk from a switch. After a port trunk
has been deleted, the ports that made up the trunk can be connected to
different end nodes.
Caution
Disconnect the cables from the port trunk on the switch before
destroying the trunk. Deleting a port trunk without first disconnecting
the cables may create loops in your network topology. Data loops
may result in broadcast storms and poor network performance.
Example
The following command deletes the trunk called load22 from the switch:
destroy switch trunk=load22
AlliedWare Plus
Command
The AlliedWare Plus command for deleting static port trunks is also the
command for removing ports from trunks. For instructions, refer to the
AlliedWare Plus command described in “DELETE SWITCH TRUNK” on
page 212.
Command
Available
AlliedWare Plus