Allied Telesis AT-S63 - Manual (Page 365)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 365
SET QOS COSP
Syntax
set qos cosp= priority-number qid= queue-number
Parameters
cosp Specifies a Class of Service (CoS) priority level. The CoS
priority levels are 0 through 7, with 0 as the lowest priority
and 7 as the highest. You can specify more than one
priority to assign to the same egress queue.
qid Specifies the egress queue number. The egress queues
are numbered 0 through 7, with queue 0 as the lowest
priority and 7 as the highest.
Description
This command maps CoS priorities to port egress queues. You must
specify both the priority and the queue ID. You can assign more than one
priority to an egress queue. Table 11 on page 362 lists the default
mappings between the eight CoS priority levels and the eight egress
queues of a switch port.
Example
The following command maps priorities 5 and 6 to egress queue 1:
set qos cosp=5,6 qid=1
Equivalent Command
map qos cosp= priority-number qid= queue-number
For information, see “MAP QOS COSP” on page 362.
AlliedWare Plus
Command
For the equivalent AlliedWare Plus command, refer to the AlliedWare Plus
Command section in “MAP QOS COSP” on page 362.
Command
Available
AlliedWare Plus