Allied Telesis AT-S63 - Manual (Page 246)

Chapter 14: Link-flap Protection Commands
246 Section I: Basic Operations
DELETE LINK-FLAP
Syntax
delete link-flap port= port |all
Parameters
port Specifies a port to remove link-flap protection. You can
remove more than one port at a time with this
command. To remove all of the ports from the feature,
use the ALL option.
Description
This command is used to remove link-flap protection from ports.
Example
This example removes link-flap protection from ports 15 to 17:
delete link-flap port=15-17
AlliedWare Plus
Command
Syntax
no link-flap protection
Mode
Port Interface mode
Description
This AlliedWare Plus command is used like the standard command to
remove link-flap protection from ports. It differs in that it disables link-flap
protection on the switch if you remove all of the ports assigned to the
feature.
Example
This example removes link-flap protection from ports 18 and 24. It
disables the feature if these are the only two ports assigned to the feature:
awplus> enable
awplus# configure terminal
awplus(config)# interface 18,24
awplus(config-if)# no link-flap protection
Command
Available
AlliedWare Plus