Set switch infiltering – Allied Telesis AT-S63 User Manual
Page 656
Chapter 34: Port-based VLAN, Tagged VLAN, and Multiple VLAN Mode Commands
656
Section VI: Virtual LANs
SET SWITCH INFILTERING
Syntax
set switch infiltering=yes|no|on|off|true|false
Parameters
infiltering
Specifies the operating status of ingress filtering.
The options are:
yes, on, true
Activates ingress filtering. The
options are equivalent. This is the
default.
no, off, false
Deactivates ingress filtering. The
options are equivalent.
Description
This command controls the status of ingress filtering. When ingress
filtering is activated, which is the default, tagged frames are filtered when
they are received on a port. When ingress filtering is deactivated, tagged
frames are filtered before they are transmitted out a port. To view the
current setting, use the “SHOW SWITCH MODULE” on page 96. For
further information on ingress filtering, refer to the AT-S63 Management
Software Menus Interface User’s Guide.
Example
The following command deactivates ingress filtering:
set switch infiltering=off