Create snmpv3 targetparams – Allied Telesis AT-S63 User Manual
Page 526
Chapter 30: SNMPv3 Commands
526
Section IV: SNMPv3
CREATE SNMPV3 TARGETPARAMS
Syntax
create snmpv3 targetparams=
targetparams
username=
username
[securitymodel=v1|v2c|v3] [messageprocessing=v1|v2c|v3]
[securitylevel=noauthentication|authentication|
privacy] [storagetype=volatile|nonvolatile]
Parameters
targetparams
Specifies the name of the SNMPv3 Target
Parameters Table entry, up to 32 alphanumeric
characters.
username
Specifies a user name configured in the SNMPv3
User Table.
securitymodel
Specifies the security model of the above user
name. The options are:
v1
Associates the User Name, or Security
Name, with the SNMPv1 protocol.
v2c
Associates the User Name, or Security
Name, with the SNMPv2c protocol.
v3
Associates the User Name, or Security
Name, with the SNMPv3 protocol.
messageprocessing
Specifies the SNMP protocol that is used to
process, or send messages. The options are:
v1
Messages are processed with the SNMPv1
protocol.
v2c
Messages are processed with the SNMPv2c
protocol.
v3
Messages are processed with the SNMPv3
protocol.
securitylevel
Specifies the security level. The options are:
noauthentication This option provides no
authentication protocol and no
privacy protocol.
authentication
This option provides an
authentication protocol, but no
privacy protocol.
Command
Available
AlliedWare Plus