Allied Telesis AT-S63 - Manual (Page 158)

Chapter 8: Port Parameter Commands
158 Section I: Basic Operations
ENABLE SWITCH PORT
Syntax
enable switch port= port
Parameter
port Specifies the port to enable. You can configure more
than one port at a time.
Description
This command enables a port. When a port is enabled, it forwards traffic.
The default setting for a port is enabled.
Example
The following command enables ports 1 to 4:
enable switch port=1-4
Equivalent Command
set switch port= port status=enable
For information, see “SET SWITCH PORT” on page 162.
AlliedWare Plus
Command
Syntax
no shutdown
Mode
Port Interface mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Example
This example enables port 22:
awplus> enable
awplus# configure terminal
awplus(config)# interface 22
awplus(config-if)# no shutdown
Command
Available
AlliedWare Plus