Allied Telesis AT-S63 - Manual (Page 705)

705
Chapter 38
Internet Protocol Version 4 Packet
Routing Commands
This chapter has the following commands:
 “ADD IP ARP” on page 706
 “ADD IP INTERFACE” on page 708
 “ADD IP RIP” on page 711
 “ADD IP ROUTE” on page 715
 “DELETE IP ARP” on page 718
 “DELETE IP INTERFACE” on page 720
 “DELETE IP RIP” on page 722
 “DELETE IP ROUTE” on page 724
 “DISABLE IP ROUTE MULTIPATH” on page 726
 “ENABLE IP ROUTE MULTIPATH” on page 727
 “PURGE IP” on page 728
 “SET IP ARP” on page 729
 “SET IP ARP TIMEOUT” on page 730
 “SET IP INTERFACE” on page 731
 “SET IP LOCAL INTERFACE” on page 733
 “SET IP RIP” on page 735
 “SET IP ROUTE” on page 739
 “SHOW IP ARP” on page 741
 “SHOW IP COUNTER” on page 743
 “SHOW IP INTERFACE” on page 745
 “SHOW IP RIP COUNTER” on page 747
 “SHOW IP RIP INTERFACE” on page 749
 “SHOW IP ROUTE” on page 752
Layer 2+ Models
AT-9408LC/SP
AT-9424T/GB
AT-9424T/SP
Basic Layer 3 Models
AT-9424T
AT-9424T/POE
AT-9424Ts
AT-9424Ts/XP
AT-9448T/SP
AT-9448Ts/XP
Supported on:
*
*
*
Yes
Yes
Yes
Yes
Yes
Yes
(*The Layer 2+ switches
support one routing interface
as an IP address.)
(**Stacks support static routes
but not the Routing Information
Protocol.)
AT-9400Ts Stacks Yes**