Allied Telesis AT-S63 - Manual (Page 819)

AT-S63 Management Software Command Line User’s Guide
Section VIII: Port Security 819
no dot1x timeout server-timeout
no dot1x max-req
Syntax for 802.1x MAC Address-based Authentication
To set a port to MAC address-based authentication:
auth-mac enable
To remove MAC address-based authentication from a port:
auth-mac disable
Mode
Port Interface mode
Description
You cannot use the AlliedWare Plus commands to set the following
authenticator port settings. To change the settings, use another
management interface:
 Operating mode
 Guest VLAN
Examples
This example sets port 2 to the authenticator role with the authentication
method of auto:
awplus> enable
awplus# configure terminal
awplus(config)# interface 2
awplus(config-if)# dot1x port-control auto
This example sets the reauthentication period to 10,000 seconds on ports
22 to 24:
awplus> enable
awplus# configure terminal
awplus(config)# interface 22-24
awplus(config-if)# dot1x timeout re-authperiod
10000
This example sets the supplicant timeout value to 80 seconds on ports 14,
17, and 21:
awplus> enable
awplus# configure terminal
awplus(config)# interface 14,17,21
awplus(config-if)# dot1x timeout supp-timeout 80