Disable interface linktrap – Allied Telesis AT-S63 User Manual
Page 153
Advertising
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
153
DISABLE INTERFACE LINKTRAP
Syntax
disable interface=
port
linktrap
Parameter
port
Specifies the port on which you want to disable SNMP
link traps. You can configure more than one port at a
time.
Description
This command disables SNMP link traps on a port. When disabled, the
switch does not send an SNMP link trap when there is a change to the
status of a link on a port.
Note
In order for the switch to send SNMP traps to SNMP trap receivers,
you must activate SNMP on the unit and specify one or more trap
receivers.
Example
The following command disables link traps on port 21:
disable interface=21 linktrap
Advertising