Disable vrrp, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 779
AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing
779
DISABLE VRRP
Syntax
disable vrrp[=
vrid
|all]
Parameters
vrrp
Specifies the ID of the virtual router. The options are:
vrid
Specifies the ID of a single virtual router,
a number between 1 and 255.
all
Specifies that the switch be removed
from all the virtual routers in which it
participates.
Description
This command disables VRRP on the switch or disables a switch’s
participation in the specified virtual router. VRRP is disabled on the switch
by default, and virtual routers are enabled by default when you create
them. You must enable both VRRP and the virtual router for the virtual
router to operate.
Example
This command disables VRRP on the switch:
disable vrrp
This command stops the switch from participating in virtual router 32:
disable vrrp=32
AlliedWare Plus
Command
Syntax
router vrrp
vrid
disable
Modes
For the ROUTER VRRP command:
Configure mode
For the DISABLE command:
Router mode
Command
Available
AlliedWare Plus