Allied Telesis AT-S63 - Manual (Page 743)

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 743
SHOW IP COUNTER
Syntax
show ip counter [port= ports |all]
Parameters
port Specifies the ports whose IP statistics you want to
display. For instructions on how to enter port
numbers, refer to “Port Numbers in Commands” on
page 48. Omitting this parameter displays the
statistics for all the ports.
Description
This command displays Layer 3 counters for the individual ports on a
switch. Figure 81 is an example of the information displayed by this
command.
Figure 81. SHOW IP COUNTER Command
The lines in the display are:
 IPInUcastPkts - Number of IP packets received on a port.
 IPOutUcastPkts - Number of IP packets transmitted from a port.
 IPInDiscards - Number of IP packets received but discarded due to
resource limitations at the IP level.
 IPInHdrErrors - Number of IP packets received with header errors.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Port 1
IPInUcastPkts ................... 0
IPOutUcastPkts .................. 0
IPInDiscards .................... 0
IPInHdrErrors ................... 0
Port 2
IPInUcastPkts ................... 0
IPOutUcastPkts .................. 0
IPInDiscards .................... 0
IPInHdrErrors ................... 0