Allied Telesis AT-S63 - Manual (Page 192)

Chapter 10: MAC Address Table Commands
192 Section I: Basic Operations
ADD SWITCH FDB|FILTER
Syntax
add switch fdb|filter destaddress|macaddress= macaddress
port= port vlan= vlan-name | vid
Note
The FDB and FILTER keywords are equivalent.
Parameters
destaddress or Specifies the static unicast or multicast address to be
macaddress added to the switch’s MAC address table. The
parameters are equivalent. The address can be
entered in either of the following formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
port Specifies the port(s) where the MAC address is to be
assigned. You can specify only one port when adding
a unicast address. You can specify more than one
port when adding a multicast address.
vlan Specifies the name or VID of the VLAN where the
node designated by the MAC address is a member.
Description
This command is used to add static unicast and multicast MAC addresses
to the switch’s MAC address table. A MAC address added with this
command is never timed out from the MAC address table, even when the
end node or, in the case of a multicast address, the multicast application is
inactive.
If you are entering a static multicast address, you must assign the address
to the port where the multicast application is located and to the ports
where the host nodes are connected. The multicast packets will not be
forwarded to the host nodes if you assign the address to only the port
where the multicast application is located.
Examples
The following command adds the static MAC address 00:A0:D2:18:1A:11
to port 7. It assumes the port where the MAC address is to be assigned is
a member of the Default_VLAN:
add switch fdb macaddress=00:A0:D2:18:1A:11 port=7
vlan=default_vlan
Command
Available
AlliedWare Plus