Allied Telesis AT-S63 - Manual (Page 44)

Chapter 1: Overview
44 Section I: Basic Operations
Figure 18. Moving from the Configure Terminal Mode to the VLAN
DATABASE Mode with the LINE CONSOLE Command
INTERFACE VLAN Command
You use this command to move from the Configure Terminal mode to the
VLAN Interface mode to create routing interfaces and to designate the
local interface. You can specify only one VLAN and the VLAN must be
indicated by its name and not by its VID. The format of the command is:
interface vlan_name
This example enters the VLAN Interface mode for the Sales VLAN.
Figure 19. Moving from the Configure Terminal Mode to the VLAN
Interface Mode with the INTERFACE VLAN Command
This example enters the VLAN Interface mode for the Default_VLAN.
Figure 20. Moving from the Configure Terminal Mode to the VLAN
Interface Mode with the INTERFACE VLAN Command
INTERFACE TRUNK Command
You use this command to move from the Configure Terminal mode to the
Static Port Trunk Interface mode, to change the load distribution methods
of static port trunks. You specify a trunk by its name of “sa” followed by its
ID number. You can specify only one static port trunk at a time. The format
of the command is:
interface trunk_name
This example enters the Static Port Trunk Interface mode for a trunk with
the name “sa2:”
awplus(config)# vlan database
awplus(config-vlan)#
awplus(config)# interface Sales
awplus(config-if)#
awplus(config)# interface default_vlan
awplus(config-if)#