Allied Telesis AT-S63 - Manual (Page 240)

Chapter 13: Port Mirroring Commands
240 Section I: Basic Operations
AlliedWare Plus
Command
Syntax
To create a port mirror or to add ports to an existing port mirror:
interface destination_port
mirror interface source_ports direction
receive|transmit|both
To remove ports from a port mirror or to disable port mirroring:
interface source_ports
no mirror interface
Mode
Port Interface mode
Description
To stop port mirroring with the AlliedWare Plus commands and to return
the destination port to normal network operations, remove all of the source
ports.
Examples
This example creates a port mirror that copies the ingress traffic on port 3,
the source port, to port 5, the destination port. If port 5 is already acting as
a destination port of a port mirror, these commands add port 3 to the port
mirror:
awplus> enable
awplus# configure terminal
awplus(config)# interface 5
awplus(config-if)# mirror interface 3 direction receive
These commands remove ports 7 and 8 from the port mirror. If these are
the only source ports in the mirror, the port mirror is disabled and the
destination port resumes normal network operations
awplus> enable
awplus# configure terminal
awplus(config)# interface 7,8
awplus(config-if)# no mirror interface