Show vrrp command information – Allied Telesis AT-S63 User Manual

Page 788

Advertising
background image

Chapter 40: Virtual Router Redundancy Protocol (VRRP) Commands

788

Section VII: Internet Protocol Routing

The information in the display is described in Table 26.

Table 26. SHOW VRRP Command Information

Section

Parameter

Description

Virtual Router Identifier

Virtual router identifier.

Configuration

VR MAC Address

Virtual router’s MAC address, derived from
the virtual router identifier.

Interface

LAN interface that the virtual router is
operating on.

Priority

Priority of the switch for assuming the master
role for the virtual router.

State

Current status of the switch in the virtual
router which may be master, backup, or initial.
Initial indicates that either the virtual router or
VRRP is disabled.

Authentication

If the virtual router uses no authentication or
plaintext or HMAC authentication.

Password

Whether or not the password is set.

IP Address(es)

Shows the IP addresses associated with the
virtual router.

Advertisement Interval

Period in seconds between advertisement
packets.

Preempt Mode

Whether preempt mode is on. When on, the
switch determines whether a higher priority
switch assumes the master role over one with
lower priority.

Preempt Delay
(seconds)

Period in seconds that the switch delays
before assuming the master role after it has
determined that its priority is greater than all
other switches. Valid only when preempt
mode is on.

Original Priority

The original priority of the port before being
affected by either the port monitoring or
monitored interface feature.

Port Monitoring

Whether the port monitoring feature is on.
This parameter is displayed only when the
virtual router operates over a VLAN interface.

Advertising