Allied Telesis AT-S63 - Manual (Page 166)

Chapter 8: Port Parameter Commands
166 Section I: Basic Operations
To enable or disable flow control:
flowcontrol receive|send on|off
To enable or disable backpressure:
flowcontrol backpressure on|off
To specify the threshold for flow control and backpressure:
bplimit value
or
fctrllimit value
To specify the threshold for head of line blocking events:
holbplimit value
To prompt a port set to Auto-Negotiation to renegotiate its speed and
duplex mode with an end node.
renegotiate
To perform a software reset:
softreset
Mode
Port Interface mode
Description
These AlliedWare Plus commands perform all the same functions as the
standard command.
Examples
This example sets the speeds on ports 11 and 17 to 100Mbps, half-
duplex:
awplus> enable
awplus# configure terminal
awplus(config)# interface 11,17
awplus(config-if)# speed 100mhalf
This example activates Auto-Negotiation on port 15:
awplus> enable
awplus# configure terminal
awplus(config)# interface 15