Allied Telesis AT-S63 - Manual (Page 96)

Chapter 3: Basic Switch Commands
96 Section I: Basic Operations
SHOW SWITCH MODULE
Syntax
show switch module=1
Parameters
None.
Description
This command displays the same information for stand-alone switches
and AT-9400Ts Stacks. An example of the display is shown in Figure 30.
Figure 30. SHOW SWITCH MODULE Command
For an AT-9400Ts Stack the first five lines apply to just the master switch.
The command accepts other module numbers, but it always displays the
same information. To determine the version numbers and build dates of
the AT-S63 Management Software on the member switches of a stack,
refer to “SHOW SYSTEM VERSION” on page 101.
This command displays the following information:
 Application software version and Application software build date - The
version number and build date of the AT-S63 Management Software.
 Bootloader version and Bootloader build date - The version number
and build date of the AT-S63 bootloader.
Switch Information:
Application Software Version ......... ATS63 v4.1.0
Application Software Build Date ...... Jul 20 2009 11:29:09
Bootloader Version ................... ATS63_LOADER v3.2.1
Bootloader Build Date ................ Jul 1 2009 11:31:24
MAC Address .......................... 00:21:46:A7:B4:43
VLAN Mode ............................ User Configured
Ingress Filtering .................... OFF
Active Spanning Tree version ......... RSTP
Mirroring State ...................... Disabled
Enhanced Stacking mode ............... Master
Console Disconnect Timer Interval .... 10 minute(s)
Web Server Status .................... Enabled
Telnet Server status ................. Enabled
Telnet insert NULL ................... OFF
MAC address aging time ............... 300 second(s)
Console Startup Mode ................. CLI
Multicast Mode ....................... Forward Across VLANs