Allied Telesis AT-S63 - Manual (Page 787)

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 787
SHOW VRRP
Syntax
show vrrp[= vrid |all]
Parameters
vrrp Specifies the ID of the virtual router. The options are:
vrid Specifies an ID of a virtual router you
want to display. The number can be from
1 and 255.
all Displays all of the virtual routers.
Description
This command is used to display information about the virtual routers. You
can display all of them or specific virtual routers.
Figure 89 is an example of the information displayed by this command.
Figure 89. SHOW VRRP Command
Command
Available
AlliedWare Plus
Virtual Router Identifier .................1
Configuration
VR MAC Address ..................... 00-00-5R-00-01-01
Interface .......................... VLAN
Priority ........................... 34
State .............................. Backup
Authentication ..................... Plaintext
Password ........................... Set
IP Address(es) ..................... 34.12.163.156
Advertisement Interval ............. 1
Preempt Mode ....................... ON
Preempt Delay (seconds) ............ 60
Original Priority .................. 34
Port Monitoring .................... ON
Step Value ......................... 40
Port Reset ......................... ON
Monitored Interfaces
Interface .......................... VLAN
New Priority ...................... 40
Counters
Good Advertisements Received ....... 0
Bad Advertisements Received ........ 0
Master Periods ..................... 1
Advertisements Sent ................ 0