Allied Telesis AT-S63 - Manual (Page 687)

AT-S63 Management Software Command Line User’s Guide
Section VI: Virtual LANs 687
DELETE VLAN
Syntax 1
delete vlan= name | vid ports= ports frame=tagged|untagged
Syntax 2
delete vlan= name | vid [taggedports= ports ]
[untaggedports= ports ]
Parameters
vlan Specifies the name or VID of the VLAN to be
modified. You can specify the VLAN by its name or
VID.
port Specifies the port to be removed from the VLAN. You
can specify more than one port at a time. This
parameter must be used with the FRAME parameter.
frame Identifies the ports to be removed as tagged or
untagged. This parameter must be used with the
PORT parameter.
taggedports Specifies the tagged ports to be removed from the
VLAN.
untaggedports Specifies the untagged ports to be removed from the
VLAN.
Description
This command removes ports from protected ports VLANs. You can use
this command to remove uplink ports and ports from groups.
Note the following before using this command:
 Both command syntaxes perform the same function. The difference is
that with Syntax 1 you can delete ports of only one type, tagged or
untagged, at a time. With Syntax 2, you can delete both types at the
same time.
 Deleting all ports from a group deletes the group from the VLAN.
 Deleted untagged ports are returned to the Default_VLAN as
untagged.
 You can delete ports from only one group at a time.