Allied Telesis AT-S63 - Manual (Page 42)

Chapter 1: Overview
42 Section I: Basic Operations
SPANNING-TREE MST CONFIGURATION Command
You use this command to move from the Configure Terminal mode to the
Multiple Spanning Tree mode to create multiple spanning tree instances.
The format of the command is:
spanning-tree mst configuration
Figure 12. Moving from the Configure Terminal Mode to the Multiple
Spanning Tree Mode with the SPANNING-TREE MST CONFIGURATION
Command
POLICY-MAP Command
You use this command to move from the Configure Terminal mode to the
Policy Map mode where flow groups are mapped to traffic classes for
Quality of Service policies. The format of the command is:
policy-map id_number
Figure 13. Moving from the Configure Terminal Mode to the Line Console
Mode with the LINE CONSOLE Command
CLASS Command
You use this command to move from the Policy Map mode to the Class
mode, to configure the traffic classes for Quality of Service policies. The
format of the command is:
class id_number
This example enters the Class mode for the traffic class with the ID
number 1:
Figure 14. Moving from the Configure Terminal Mode to the Class Mode
with the CLASS Command
awplus(config)# spanning-tree mst configuration
awplus(config-mst)#
awplus(config)# policy-map 1
awplus(config-pmap)#
awplus(config-pmap)# class 1
awplus(config-pmap-c)#