Allied Telesis AT-S63 - Manual (Page 71)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 71
RESET SYSTEM
Syntax
reset system [name] [contact] [location]
Parameters
name Deletes the switch’s name.
contact Deletes the switch’s contact.
location Deletes the switch’s location.
Description
This command is used to delete the switch’s name, the name of the
network administrator responsible for managing the unit, and the location
of the unit. To set these parameters, refer to “SET SYSTEM” on page 85.
To view the current settings, refer to “SHOW SYSTEM” on page 99.
Examples
This command deletes all three parameter settings:
reset system
This command deletes just the name:
reset system name
AlliedWare Plus
Command
Syntax
no hostname
Mode
Configure mode
Description
You use this command to delete the switch’s name. You cannot delete the
contact or the location from the AlliedWare Plus command interface.
Command
Available
AlliedWare Plus