Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 830
Chapter 42: 802.1x Port-based Network Access Control Commands
830
Section VIII: Port Security
This command displays the configuration settings and the status for port
10:
show portaccess port=10
This command displays the configuration settings and status for port 12
which is a MAC address-based authenticator port:
show portaccess=macbased port=12
This command displays just the status information for supplicant port 17:
show portaccess port=17 supplicant status
AlliedWare Plus
Command
Syntax
show dot1x statistics
show auth-mac interface
port
|all
Modes
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus SHOW DOT1X INTERFACE command displays a
combination of the information from the following standard commands:
show portauth port=all authenticator|supplicant config
show authentication
For information on these commands, refer to “SHOW
PORTACCESS|PORTAUTH PORT” on page 828 and “SHOW
AUTHENTICATION” on page 896.
The SHOW AUTH-MAC INTERFACE command is equivalent to the
MACBASED option in the standard command.
Example
awplus# show dot1x statistics
awplus# show auth-mac interface 1-4