Enable mldsnooping, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 487
Advertising
AT-S63 Management Software Command Line User’s Guide
Section III: Snooping Protocols
487
ENABLE MLDSNOOPING
Syntax
enable mldsnooping
Parameters
None.
Description
This command activates MLD snooping on the switch.
Example
The following command activates MLD snooping:
enable mldsnooping
Equivalent Command
set ipv6 mldsnooping snoopingstatus=enabled
For information, refer to “SET IPV6 MLDSNOOPING” on page 488.
AlliedWare Plus
Command
Syntax
ip mld snooping
Mode
Configure mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Example
awplus> enable
awplus# configure terminal
awplus(config)# ip mld snooping
Command
Available
AlliedWare Plus
Advertising