Restart reboot, Alliedware plus command – Allied Telesis AT-S63 User Manual
Page 73
AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations
73
RESTART REBOOT
Syntax
restart reboot
Parameters
None.
Description
You use this command to reset stand-alone switches and stacks. You
might reset a unit if it is experiencing a problem. The reset takes from
twenty seconds to two minutes.
Note
Switches and stacks do not forward traffic while they are resetting.
Some network traffic may be lost.
Note
Be sure to save your changes to active boot configuration file before
resetting a switch or stack. Any unsaved changes will be lost.
Your local or remote management session ends when you reset a unit. To
continue the management session, you must reestablish it.
To reset individual switches in a stack, refer to “RESTART SWITCH” on
page 75.
Example
The following resets a switch or stack:
restart reboot
AlliedWare Plus
Command
Syntax
system reboot
Mode
Privileged Exec mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Command
Available
AlliedWare Plus